Immediately press and hold button 1 or 2 until two beeps sound. Press and release the MEM (Memory) button (D). Adjust the driver’s seat and power outside mirrors to the desired positions.Ģ. Lift the lever to adjust the seatback position.ġ. Move the large control to move the seat forward or rearward and to tilt, raise or lower the seat. Press the small control to adjust the lumbar support. The Driver Information Center (DIC) on the instrument cluster displays a variety of vehicle messages and system information. Press and hold the button to reset a menu item. Press the button on the end of the lever to view or set a menu item or clear a message. Rotate the switch to scroll through the items of each menu. Press to display the Info menu (speed-ometer, trip odometers, fuel range, oil life, fuel economy and tire pressure), Navigation menu (cancel guidance and voice prompt), or Options menu (units and info pages). See Driving and Operating in your Owner's Manual. The amber button indicator will illuminate. With the engine off and the brake pedal not depressed, press the ENGINE START/STOP button to place the vehicle in accessory mode. Shift to Park and then press and hold theĞNGINE START/STOP button until the engine turns off. Replace the transmitter battery as soon as possible. Note: If the transmitter battery is weak, place the transmitter in the front cupholder in the center console to enable the engine to start. The green button indica-tor will illuminate. With the transmission in Park or Neutral, press the brake pedal and then press the ENGINE START/STOP button. The Remote Keyless Entry transmitter must be in the vehicle to turn on the ignition. Note: To change the door lock settings, go to Settings > Vehicle > Remote Lock, Unlock, Start. If Passive Locking is turned on, all doors and the liftgate will lock automatically after a short delay once all doors and the liftgate are closed. Press the button on any door handle to lock all doors and the liftgate immediately. With the ignition off, the transmitter out of the vehicle, and all doors closed: Press the touchpad on the liftgate handle to open the liftgate. Press the button on the passenger’s door han-dle to unlock all doors and the liftgate. Press the button on the driver’s door handle to unlock the driver’s door press it again within 5 seconds to unlock all doors and the liftgate. The transmitter must be within 3 feet of the door to be unlocked or within 3 feet of the liftgate. KeylessĚccess enables operation of the doors and liftgate without removing the Remote Keyless Entry transmitter from a pocket or purse. See Keys, Doors and Windows in your Owner's Manual. Note: To change the remote start settings, go to Settings > Vehicle > Remote Lock, Unlock, Start. Repeat these steps to run the engine for an additional 15 minutes. Press and hold the button until the parking lamps turn off to cancel a remote start.ĭuring a remote start, the engine will run for 15 minutes. Press and release the Lock button and then press and hold the Remote Startīutton until the turn signal lamps flash.Ěfter entering the vehicle, turn on the ignition. Use Remote Vehicle Start to start the engine from outside the vehicle. See Instruments and Controls in your Owner's Manual. Pull up the lever to lock the steering wheel in place. The steering wheel can then be moved up or down and in or out. With the vehicle parked, push down the lever on the left side of the steering column to adjust the steering wheel.
0 Comments
Leave a Reply. |